Knife blocks

by Julie Finch-Scally

I was cleaning my kitchen bench the other day and moved the knife block to clean under and behind. As I moved the block I noticed the dust sitting on the flat surface between the knife handles. From the look of the dust it must have been there for quite some time, but I hadn’t noticed it before. I realised the block, especially that flat surface had to be cleaned.

As with all knife blocks there are holes to house the knives. This means submerging the block in hot soapy water is not a clever idea because the water will soak down into the holes and make the inside of the block wet. This will affect the knives and in the end ruin the whole block.

After removing all the knives and scissors that sit in the block I rubbed down the sides with a damp cloth that had been rinsed in hot soapy water. The sides were shiny so they had been covered with lacquer which was a protection. Using a damp cloth to wipe the sides was not a problem. I did dry it with a tea towel after I had removed marks and dirt.

But it was the top of the block where the knife handles sat that I was more concerned about. That was the dustiest spot and I did not want to use any water, as the rim of the holes needed to be cleaned as well as the top surface.

I finally decided to use a micro-fibre cloth with some multi-purpose spray to wipe over the top and rub the hole edges. This worked well and made the top surface look much cleaner. But I knew leaving that surface unprotected was going to be a problem in the future.

My first thought was to use furniture polish over the area, but as all the polishes in my house are made with oils, they would only penetrate the surface and not cover the surface to protect it. It meant a trip to the supermarket where I purchased a furniture polish with silicon.

Many years ago furniture polish with silicon was the preferred polish, until people realised the polish was sitting on the top of the surface and not being absorbed into the wooden furniture which it required. Actually the silicon furniture polish became more useful for protection of other articles of furniture not made of wood, especially water proofing marble bench tops. But as sales of silicon contained polish declined it has become more difficult to find. Thankfully there was one version on the supermarket shelf.

When I got the can home I spray the polish onto a polishing cloth and rubbed it over the top surface of the knife block and around the edges of the holes. After the initial coating of the top surface I actually sprayed the surface so some of the polish could penetrate down into the holes. I then completely wiped over all the knife block with the polishing cloth to remove any excess and coat the sides.

I must admit, because of the shine of the polish the knife block does look a lot better. It is not only clean, but in shines and make the knives look elegant.

 

Add Question


Security code
Refresh

Cleaning Book - Buy Now

Novel Tips

Video

Video

Contact Julie on

to engage her services.

In The News

Career One

Career One

Take a new broom to your life and clean up. When fifty- something Julie Finch-Scally walked out of her job with a bank, she struggled to find new work. "It... Read more

Herald Sun

Herald Sun

Clean break from misconceptions. JULIE Finch-Scally is on a mission to change the perception of cleaners. Now 70, she started cleaning 19 years ago when she quit her job at... Read more

Daily Telegraph

Daily Telegraph

Talking up new broom. JULIE Finch-Scally was unhappy when she lost her job in banking. However, instead of lamenting her luck, which only got worse when she found it difficult... Read more